Board logo

blade beast 10m
christian - 21-7-2008 at 15:21

hi new to sport having purchased above kite the beast tends to fall back out of sky and not very responsive on turning has anyone any ideas fine tuning ok but unresponsive sometimes thanks


shem - 22-7-2008 at 08:41

falling back is caused by back lines being to tight, slow turning caused by the opposite, so doubt it could be tuned any better, probably just how it is. Try finding some one else that has one, maybe try the flexi forum.


christian - 22-7-2008 at 10:52

thanks for reply tried blade .com to find out why kite acts the way it does but to no avail ill try flexi forum some one must have a blade kite thanks


christian - 1-8-2008 at 08:57

hi set kite up set up was for average winds,rear lines on second knot,going through power zone from 2 to 11 kite seemed to turn slowly then all of a sudden wack landed checked pulleys ok launched again waterstart dived kite and no response line lenghts are 21m could it be this kite inflated properly another kiter tried and did exactly the same hes been kiting for 3 years even he coudnt figure it out tried flexi forum but cannot register